Providing Kubvan info for 21 years, please help support this site

Camper Van

Purist will want to avoid this section.
How wild and woolly can your ride get.
Suspension, Engines, what you go that' not stock

Camper Van

Postby luckham » Fri Dec 27, 2013 1:05 am

kub stretch-1011852.jpg
kub stretch-1011852.jpg (54.94 KiB) Viewed 12052 times

Thanks to George, I started installing the roof extrusions to complete the 18 inch stretch.
I Now have everything fabricated and test fitted.
Riveting starts next, if there are no glitches the back panel will be back on soon.
User avatar
luckham
Site Admin
 
Posts: 140
Joined: Fri Dec 16, 2011 11:56 pm

Re: Camper Van

Postby luckham » Wed Jan 08, 2014 11:53 pm

Well the rear panel and doors are back on the van is now 18 inches longer. A full 7 feet of interior box length.
Back on.jpg
Back on.jpg (86.57 KiB) Viewed 12030 times

Now its time to patch the roof, if there is going to be a skylight this must be the spot.
skylight opening.jpg
skylight opening.jpg (71.78 KiB) Viewed 12030 times


All ideas welcome, I have the glass, hinges and catch from a mazda sun roof/skylight I would just have to figure out how to make the frame, the glass is bowed.
Anybody know of any flat sunroofs/skylights on other vehicles that might easily be fitted to a kubvan ?
User avatar
luckham
Site Admin
 
Posts: 140
Joined: Fri Dec 16, 2011 11:56 pm

Re: Camper Van

Postby CRSMP5 » Thu Jan 09, 2014 12:27 pm

stop.... go look for flat panels like rear of ups/fed-x truck... they been doing full length translucent and i cannot beleive a smoked or almost clear one by this point is not made..

for venting... use a croch vent from by door.... what grumman used on kurbwats to vent them up top... they put it by the dome light...
CRSMP5
 
Posts: 215
Joined: Thu Dec 29, 2011 2:46 pm

Re: Camper Van

Postby luckham » Sat Jan 18, 2014 1:01 pm

Skylight outside.jpg
Skylight outside.jpg (70.52 KiB) Viewed 12008 times

Thanks Burnt toast, opened my horizons to look for alternatives and found this at the wrecker.
Its the glass out of a flat deck truck wind fairing it fits perfect, tempered glass aluminum frame, and looks great.
Its got a nice flange on the inside so I can caulk it and snug up tight, should never leak.
Skylight inside.jpg
Skylight inside.jpg (76.58 KiB) Viewed 12008 times
User avatar
luckham
Site Admin
 
Posts: 140
Joined: Fri Dec 16, 2011 11:56 pm

Re: Camper Van

Postby CRSMP5 » Sat Jan 18, 2014 8:18 pm

glad i got the screws turning... looks good...
CRSMP5
 
Posts: 215
Joined: Thu Dec 29, 2011 2:46 pm

4X4 camper van update

Postby luckham » Fri Apr 03, 2015 8:43 pm

It's been a while since I posted here. I hacve been jumping back and forth between this and the EV project.
I have had some significant progress in the last few weeks on the 4X4.
Short story is :
The 1.9 TD is connected to a yota 4X4 transmission with an ACME adapter plate and working.
The motor and tranny are now suspended in the vehicle in the mounting location.
The drive shaft is connected to the rear differential with the original yota drive shaft. This was not planned that way but it fits perfect. (52inches)
The front drive shaft for the hard axle needs to be shortened 9 inches.
The steering shaft is through the firewall and inches from the Pitman gear box for the original steering connections for the Toyota, again can't believe that it lines up so nicely. See the photos for the details of all the above.

20150403_180712.jpg
20150403_180712.jpg (47.68 KiB) Viewed 7412 times

20150403_180420.jpg
20150403_180420.jpg (49.63 KiB) Viewed 7412 times

Motor Installation
20150403_180440.jpg
20150403_180440.jpg (47.46 KiB) Viewed 7412 times

passenger side view thru wheel well
20150403_180502.jpg
20150403_180502.jpg (47.89 KiB) Viewed 7412 times

Transmission, drive shaft
20150403_180517.jpg
20150403_180517.jpg (50.73 KiB) Viewed 7412 times

20150403_180618.jpg
20150403_180618.jpg (50.7 KiB) Viewed 7412 times

Differential and drive shaft connection
20150403_183200.jpg
20150403_183200.jpg (53.62 KiB) Viewed 7412 times

Steering coupling



Next steps include:
Fabricating the motor mounts, now that the final position is confirmed.
Mount the power steering pump on the left side of the engine.
Connect the hydraulic clutch.
Finalize the mounting of the new front shocks.
Finalize the front seat configuration, install stick shifts and close in the floor.
Finalize the new fuel tank configuration. (2 tanks left and right in that cavity below the floor and behind the seats.)
Install radiator turbo filter, ducting and front grill.
Figure out and install exhaust system.
Finalize camper fittings.
Go camping ...........

The list is mostly for my own tracking.
I am happy with the progress thru the winter, definitely reached the point where it looks like it is all going to work.
Watch for further progress thru the spring/summer.
User avatar
luckham
Site Admin
 
Posts: 140
Joined: Fri Dec 16, 2011 11:56 pm

Re: Camper Van

Postby luckham » Thu Aug 02, 2018 11:23 pm

Time marches on much faster than this project.
That said, significant investment in sub-component preparation this year has finally reaped rewards.
This past week the VW 1.9 litre TDI engine and the Toyota 4X4 tranny have been re-installed. The rear suspension and differential were also installed.
The van now sits on it's tires and rolls back and forth with no issues.
Engine wiring harness, ECU, clutch, and steering box next, oh still needs a radiator :).
With brakes, general vehicle electrics, the interior and cosmetics to follow.
There is a faint glimmer of hope that the "Camper Van" may be attending the 2019 Island folk festival. (Music not Volks)
Attachments
Camper Van August (3) sm.jpg
KubVan 4X4
Camper Van August (3) sm.jpg (124.81 KiB) Viewed 529 times
Camper Van August (2) sm.jpg
KubVan 4X4
Camper Van August (1) sm.jpg
KubVan 4X4
Camper Van August (1) sm.jpg (77.63 KiB) Viewed 529 times
User avatar
luckham
Site Admin
 
Posts: 140
Joined: Fri Dec 16, 2011 11:56 pm


Return to Custom & Mods

Who is online

Users browsing this forum: No registered users and 1 guest

Providing Kubvan info for 15 years, please help support this site
cron